Wilson Electronics — Page 4

Wilson Electronics

on March 11, 2010  



Dear Booster Bob, My wife and I have iPhones and need better reception in fringe areas. What do you have for this? I need it for my car or camper. John, I recommend the Wilson 801212 – it’s a mobile cell signal amplifier that’s perfect for campers and vehicles. It comes with an exterior antenna [...]

on March 10, 2010  



Both cell carriers and cell signal booster makers are calling on the Federal Communications Commission to take action regarding signal boosters. The FCC is considering legislation that would make cell signal boosters illegal unless they are released by wireless operators or consented from a wireless operator. Wilson Electronics believes that setting standards for signal boosters [...]

on February 26, 2010  



The Consumer Electronics Association chose Wilson Electronics MobilePro signal booster as one of four finalists for Wireless Product of the Year in association with 2010 Mark of Excellence Awards. The Mark of Excellence Award honors innovation in custom home electronics products, services and installation technologies. Companies submit entries to the Supplier and System Integrators categories [...]

on February 9, 2010  



Verizon Wireless, U.S. Cellular and the CTIA have commented to the FCC against Wilson Electronic’s petition to raise standards for cell signal boosters. Verizon and U.S. Cellular state that cell signal boosters have caused network interference again and again, even when the boosters are up to the standards Wilson has petitioned for in its FCC [...]

on February 4, 2010  



Wilson Electronics has asked the Federal Communications Commission to raise its certification standards for cell phone signal boosters to prevent interference to service providers’ networks and equipment while increasing customer satisfaction. In November 2009, Wilson submitted a ‘Petition for Rulemaking’ to the FCC recommending additional tests that cell signal boosters must pass in order to [...]

on January 4, 2010  



Wilson Dual-Band In-Building Wireless Kit The Wilson Dual-Band In-Building Wireless Kit (841262) is important for those looking to improve cell and data transfer where there’s a weak signal for a small office or house. Its dual-band allows it to work with both 900Mhz and 1900Mhz frequencies, but doesn’t work with Nextel’s Push-to-Talk network or the [...]

on August 14, 2009  



… Installs in minutes – no special tools required

on August 14, 2009  



The Wilson 301129 800MHz 10dB Yagi Antenna is a 800MHz/iDEN antenna with 10 dB of gain.